LinkPi ENC1-V3 external buttons on the front panel

Thanks for your support. Please advise what can be done if the front buttons stop responding. I’d like to quick turn on the recording and start streaming. There is no mention of buttons in the “Extend-Serial, Button” (uart.php) section of the menu.
Thank you!

Thanks. I enabled the buttons menu via fac.php but they still don’t work. Do I need to make additional GPIO settings?

Hi! Can you please give more information about the buttons. They do not work.Thank you.

Try updating to the latest firmware.

I did it without success so far.

It was finally confirmed that the V3 does not support custom buttons for the time being.
You can refer to the source code for modification.