[Information integration, you can view the tutorial and download the source code and firmware from here.]
- Prepare 8G/above TF card, USB-Serial interface, PC
- Using your USB-Serial Connect debug console on P2 Zero
Connect your board to the serial port, open the terminal software, and set the baud rate to 115200.
Burn the system image according to the tutorial below.
Getting Started with P2-Zero - Banana Pi Wiki
3.Because P2-ZERO and M2-ZERO are the same chip, if you use armbian , you can referenc to this video.
If you have any questions, please reply to the exchange.